a question about the combinati < Matlab < Mathe-Software < Mathe < Vorhilfe
|
Hallo, my friends, i have a question about the combination between
GUI and simulink. I have made a model with simulink, in this model i
use a NIDAQ card to measure 1 valtage and then after calcultion give
a new valtage out. at the same time i have made a small GUI with
matlab. in this GUI i put s buttons, one button named start, with
this button i want to start the simulink model and at the same time
measure the valtage, then draw it in the GUI. i draw the valtage once
every one second. that is, this control loop is a little bit like
real time. but i must not use the real time workshop or something
like that. because for me once measure per second is enough. what i
want to do is, when the model runs, i measure the voltage once per
second and save the data in workspace or somewhere. and the GUI draw
the curve of the voltage. but my problem is, i don't know how to save
the data(voltage). because when the model runs i can't save the data,
or i don't how to access the data. only after the simulation of the
model is over, can I access the data. how can i save and take the
data during the simulation?
can someone give some tipps?
thank you very much!
Ich habe diese Frage in keinem Forum auf anderen Internetseiten gestellt.
|
|
| |
|
| Status: |
(Mitteilung) Reaktion unnötig  | | Datum: | 13:20 Do 08.03.2007 | | Autor: | matux |
$MATUXTEXT(ueberfaellige_frage)
|
|
|
|
